Increase/decrease the magnitude of the EMFs and the resistors by clicking on the
upper/lower part of the object.

The values of the resistors range from 1 to 10 ohms; the values of the EMFs range
from -10 to +10 volts.

The ammeters show the currents in the wires; the voltmeters show the voltages across
the resistors.

The circuit consists of a loop ABCDEF and the following components attached to each
of it's three branches: an EMF, an Ammeter which measures the current through that
branch, a resistor (except for branch B), and a Voltmeter which measures the potential
rise/drop on the resistor. The values for each of the components can be seen either
next to or written on the components themselves. It should be made clear that the
Ammeters and Voltmeters are positioned in such a way that they will show a positive
reading when the current is flowing from top to bottom, although such a selection
is made in this circuit it would have been just as correct to pick it's opposite.

These three basic rules/formulas are needed to solve the system of equations envolved:

- Kirchhoff's Junction Rule
- Kirchhoff's Loop Rule
- Ohm's Law (i.e.
**V/I = R**, where **I** is the current, **V** is the voltage,
and **R** is the resistance)

To solve the equations we will need to name our components, we have chosen a system
in which each component is named by a letter indicating it's type (**I** for
current, **ε** for the EMF, and
**R** for resistance) and a subletter indicating it's branch (A, B, or C). Thus
the current in the leftmost branch would be (by **Ohm's Law**): **I**_{A}
= V_{A}/R_{A}. Now we are ready to formulate the system.

First, we take the outer most loop ACDF and use the **Junction Rule**. Let's
take junction B, since we assume that all of the currents flow from top to bottom,
the sum of the currents heading out of the loop is equal to zero (since no current
is heading in) i.e.,

**I**_{A} + I_{B} + I_{C} = 0

Next we take loop ABEF and apply the **Loop Rule**, which says that the sum of
the potential rises must equal to the sum of the potential drops i.e.,

**ε**_{A} + I_{A}*R_{A}
= ε_{B}

We can also apply this rule to the outer loop, ACDF, getting:

**ε**_{A} + I_{A}*R_{A}
= ε_{C} + I_{C}*R_{C}

Let us summarize our system of three equations:

**I**_{A} + I_{B} + I_{C} = 0

**ε**_{A} + I_{A}*R_{A}
= ε_{C} + I_{C}*R_{C}

**ε**_{A} +I_{A}*R_{A}
= ε_{B}

Solving for the currents we get:

**I**_{A} = (ε_{B} - ε_{A})/R_{A}

**I**_{C} = (ε_{A} - ε_{C})/R_{C} + I_{A}*(R_{A}/R_{C})

**I**_{B} = -I_{A} - I_{C}

Therefore, since the resistance, **R**, and the EMF, **E**, are known for
each of the branches, the currents, **I**, are calculated by the above method.

The voltage across the resistors is arrived at as follows: (let **V** be the
voltage across the resistor, by Ohm's Law)

**V = IR**