CP Workbook
Power Transmission
Printer Friendly Version
Many power companies provide power to cities that are far from the generators.
Refer to the following information for the next question.
Consider a city of 100,000 persons who each use continually use 120 W of power (equivalent to the operation of two 60-W light bulbs per person). The power constantly consumed is
100,000 persons x 120 W/person = 12 million W (12 MW).
What current corresponds to this amount of power at the common 120 V used by consumers?
Refer to the following information for the next question.
This is an enormous current, more than can be carried in the thickest of wires without overheating. More power would be dissipated in the form of heat than would reach the faraway city. Fortunately the important quantity is IV and not I alone. Power companies transmit power over long distances at very high voltages so that the current in the wires is low and heating of the power lines is minimized.
If the 12 MW of power is transmitted at 120,000 V, the current in the wires is
Refer to the following information for the next three questions.
This amount of current can be carried in long-distance power lines with only small power losses due to heating (normally less than 1%). But the corresponding high voltages wired to houses would be very dangerous. So step-down transformers are used in the city.
What ratio of primary turns to secondary turns should be on a transformer to step 120,000 V down to 2400 V?
What ratio of primary turns to secondary turns should be on a transformer to step 2400 V down to 120 V used in household circuits?
What is the main benefit of ac compared to dc power?
Related Documents
Lab:
CP -
Series and Parallel Circuits
Labs -
Parallel and Series Circuits
Labs -
RC Time Constants
Labs -
Resistance and Resistivity
Labs -
Resistance, Gauge, and Resistivity of Copper Wires
Labs -
Telegraph Project
Labs -
Terminal Voltage of a Lantern Battery
Labs -
Wheatstone Bridge
Resource Lesson:
RL -
A Comparison of RC and RL Circuits
RL -
A Special Case of Induction
RL -
Ampere's Law
RL -
An Introduction to DC Circuits
RL -
Capacitors and Dielectrics
RL -
Dielectrics: Beyond the Fundamentals
RL -
Eddy Currents plus a Lab Simulation
RL -
Electricity and Magnetism Background
RL -
Filaments
RL -
Generators, Motors, Transformers
RL -
Induced Electric Fields
RL -
Induced EMF
RL -
Inductors
RL -
Kirchhoff's Laws: Analyzing Circuits with Two or More Batteries
RL -
Kirchhoff's Laws: Analyzing DC Circuits with Capacitors
RL -
LC Circuit
RL -
Magnetic Field Along the Axis of a Current Loop
RL -
Magnetism: Current-Carrying Wires
RL -
Maxwell's Equations
RL -
Meters: Current-Carrying Coils
RL -
Motional EMF
RL -
Parallel Plate Capacitors
RL -
RC Time Constants
RL -
RL Circuits
RL -
Torque on a Current-Carrying Loop
Review:
REV -
Drill: Induction
Worksheet:
APP -
The Circuit Rider
APP -
The Cycle Shop
CP -
DC Currents
CP -
Electric Power
CP -
Induction
CP -
Ohm's Law
CP -
Parallel Circuits
CP -
Power Production
CP -
RIVP Charts #1
CP -
RIVP Charts #2
CP -
Series Circuits
CP -
Transformers
NT -
Brightness
NT -
Induction Coils
NT -
Light and Heat
NT -
Parallel Circuit
NT -
Series Circuits
NT -
Shock!
WS -
Capacitors - Connected/Disconnected Batteries
WS -
Combinations of Capacitors
WS -
Induced emf
WS -
Introduction to R | I | V | P Charts
WS -
Kirchhoff's Laws: DC Circuits with Capacitors
WS -
Kirchhoff's Laws: Sample Circuit
WS -
Practice with Induced Currents (Changing Areas)
WS -
Practice with Induced Currents (Constant Area)
WS -
Resistance, Wattage, and Brightness
TB -
34A: Electric Current
TB -
35A: Series and Parallel
TB -
Advanced Capacitors
TB -
Basic Capacitors
TB -
Basic DC Circuits
TB -
Multiple-Battery Circuits
TB -
Textbook Set #6: Circuits with Multiple Batteries
Paul G. Hewitt
Copyright © 1984-2005
All rights reserved.
Used with written
permission.
PhysicsLAB
HTML conversion
Copyright © 1997-2017
Catharine H. Colwell
All rights reserved.
Mainland High School
Daytona Beach, FL 32114