Lab
Video Lab: M&M Collides with Pop Can
Printer Friendly Version
This lab is based on a
Direct Measurement Video
called
M&M Colliding with Pop Can
released on the
Science Education Research Center
(SERC) website. The copyright for this video belongs to Independent School District 197 in Mendota Heights MN. The project is partially funded by a
National Science Foundation Grant (#1245268)
awarded in September 2013.
The following lab directions were designed for use in my Honors Physics I class and only represent one method of analyzing the data provided in the video.
By using the data from the video, you will be able to calculate the momentum of the M&M and pop can both before and after a collision. Then we will discuss conservation of momentum and any changes in KE during the collision. But, before taking any measurements, you should view the video several times to acquaint yourself with its scenario.
Data stated on the video:
mass of the can equals 13.0 ± 0.1 grams
mass of the M&M equals 2.3 ± 0.1 grams
recording frame rate equals 960 frames/second.
Refer to the following information for the next seven questions.
During the first frames of the video, an M&M is blown out of a pneumatic tube and travels across the screen to collide with a stationary can of Coke. On frames-5 the right side of the M&M is barely visible as it start to emerge from the tube.
Based on the graph shown above, how far does the M&M travel between frames-5 and frames-4?
Based on the graph shown above, how far does the M&M travel between frames-4 and frames-3?
Based on the graph shown above, how far does the M&M travel between frames-3 and frames-2?
What was the average value of the distance traveled by the M&M during each frame progression?
What was the M&M's average speed before it struck the Coke can?
What was the M&M's momentum before it struck the Coke can?
What was the M&M's KE before it struck the Coke can?
Refer to the following information for the next four questions.
In the next section, the M&M strikes the can, drills through the can, flies off the screen by itself followed by the can also flying off by itself.
On frames+0, the M&M emerges from the can. On which frame is the leading edge of the M&M at 29 cm?
What was the M&M's average speed after it emerges from its collision with the Coke can?
On frames+14, the Coke can's center of mass (yellow circle) is completely off the table. On which frame was the can's center of mass at 28 cm?
What was the can's average speed after it leaves the table?
Refer to the following information for the next six questions.
Now you will examine the momenta of the M&M and Coke can after the collision.
What was the M&M's momentum after its collision with the Coke can?
What was the M&M's KE after its collision with the Coke can?
What was the Coke can's momentum after the collision with the M&M?
What was the Coke can's KE after the collision with the M&M?
What was the total momentum of the "M&M and Coke can" system after the collision?
What was the total KE of both the "M&M and Coke can" together after the collision?
Refer to the following information for the next six questions.
Conclusions
Do your answers for the total momentum of the "M&M and Coke can" system before the collision and the total momentum of the "M&M and Coke can" system after the collision verify that momentum was conserved in this collision?
yes
no
Support your choice in the previous question.
What is the percent difference between the total momentum in the system before the collision and the total momentum in the system after the collision?
What percentage of the M&M's original KE was lost during the collision?
Was this collision elastic or inelastic?
What impulse did the Coke can give to the M&M in this collision?
Related Documents
Lab:
Labs -
A Battering Ram
Labs -
A Photoelectric Effect Analogy
Labs -
Air Track Collisions
Labs -
Ballistic Pendulum
Labs -
Ballistic Pendulum: Muzzle Velocity
Labs -
Bouncing Steel Spheres
Labs -
Collision Pendulum: Muzzle Velocity
Labs -
Conservation of Energy and Vertical Circles
Labs -
Conservation of Momentum
Labs -
Conservation of Momentum in Two-Dimensions
Labs -
Impulse
Labs -
Inelastic Collision - Velocity of a Softball
Labs -
Loop-the-Loop
Labs -
Ramps: Sliding vs Rolling
Labs -
Roller Coaster, Projectile Motion, and Energy
Labs -
Rotational Inertia
Labs -
Rube Goldberg Challenge
Labs -
Spring Carts
Labs -
Target Lab: Ball Bearing Rolling Down an Inclined Plane
Labs -
Video LAB: Ball Re-Bounding From a Wall
Labs -
Video Lab: Blowdart Colliding with Cart
Labs -
Video Lab: Cart Push #2 and #3
Labs -
Video LAB: Circular Motion
Labs -
Video Lab: Marble Collides with Ballistic Pendulum
Resource Lesson:
RL -
A Further Look at Impulse
RL -
APC: Work Notation
RL -
Conservation of Energy and Springs
RL -
Energy Conservation in Simple Pendulums
RL -
Famous Discoveries: The Franck-Hertz Experiment
RL -
Gravitational Energy Wells
RL -
Linear Momentum
RL -
Mechanical Energy
RL -
Momentum and Energy
RL -
Potential Energy Functions
RL -
Principal of Least Action
RL -
Rotational Dynamics: Pivoting Rods
RL -
Rotational Kinetic Energy
RL -
Springs and Blocks
RL -
Symmetries in Physics
RL -
Tension Cases: Four Special Situations
RL -
Work
RL -
Work and Energy
Worksheet:
APP -
Puppy Love
APP -
The Jogger
APP -
The Pepsi Challenge
APP -
The Pet Rock
APP -
The Pool Game
APP -
The Raft
CP -
Conservation of Energy
CP -
Conservation of Momentum
CP -
Momentum
CP -
Momentum and Energy
CP -
Momentum and Kinetic Energy
CP -
Momentum Practice Problems
CP -
Momentum Systems and Conservation
CP -
Power Production
CP -
Satellites: Circular and Elliptical
CP -
Work and Energy
NT -
Cliffs
NT -
Elliptical Orbits
NT -
Escape Velocity
NT -
Gravitation #2
NT -
Ice Boat
NT -
Momentum
NT -
Ramps
NT -
Satellite Positions
WS -
Advanced Properties of Freely Falling Bodies #1
WS -
Advanced Properties of Freely Falling Bodies #2
WS -
Advanced Properties of Freely Falling Bodies #3
WS -
Charged Projectiles in Uniform Electric Fields
WS -
Energy Methods: More Practice with Projectiles
WS -
Energy Methods: Projectiles
WS -
Energy/Work Vocabulary
WS -
Force vs Displacement Graphs
WS -
Introduction to Springs
WS -
Kinematics Along With Work/Energy
WS -
Potential Energy Functions
WS -
Practice: Momentum and Energy #1
WS -
Practice: Momentum and Energy #2
WS -
Practice: Vertical Circular Motion
WS -
Rotational Kinetic Energy
WS -
Static Springs: The Basics
WS -
Work and Energy Practice: An Assortment of Situations
WS -
Work and Energy Practice: Forces at Angles
TB -
Work, Power, Kinetic Energy
Direct Measurement Video Project
Peter Bohacek
Copyright © 2013-2017
All rights reserved.
Used with
permission
.
PhysicsLAB
Lab Implementation
Copyright © 2014-2017
Catharine H. Colwell
All rights reserved.
Application Programmer
Mark Acton